MicroTrainer – CAN Basics Training Kit

Build Your Wishlist

The first step to securing funding is building a plan for your program. Let us help you get started.

SBC

// SBC-CB-24

MicroTrainer – CAN Basics Training Kit

Introducing the world’s smallest Simulated CAN Bus Trainer for Multimeter Diagnostics. While this is NOT a live CAN bus system, the Micro Trainer CAN Basic produces static DC voltage levels that simulate what a digital multimeter reads on an active CAN bus. You will not see toggling CAN frames on an oscilloscope – this board is purpose-built for teaching multimeter-based CAN bus diagnostics, the first step in any roadside or flightline troubleshooting workflow. But it will give your students a safe, battery-powered circuit board to practice the voltage and resistance measurements used to diagnose CAN bus faults – without needing a vehicle, aircraft, or expensive bench equipment. Students learn to identify normal bus voltages, correct termination resistance, and five common fault conditions using only a standard multimeter.

Each classroom kit includes 24 trainers in a Milwaukee PACKOUT case with custom-cut foam inserts for secure storage and transport.

Product Details

Realistic CAN bus voltages – CAN_H reads ~2.7V, CAN_L reads ~2.2V, differential ~0.5V (matches real-world multimeter-averaged values)
5 fault injection switches – CAN_H shorted to ground, CAN_L shorted to ground, CAN_H-CAN_L short, open bus segment, and incorrect termination (60 ohm vs 120 ohm)
LED status indicators – Green/red module status LEDs for ECM, TCM, and BCM, plus COMM DEGRADED and NO COMM indicators show students the system-level impact of each fault
11 labeled test points – Large pads sized for multimeter probe tips, clearly marked with expected readings
Battery powered – Single CR2032 coin cell, no external power needed. Low-battery LED warns when replacement is needed
Compact and portable – Flat SMD construction, fits in a tool bag or classroom kit

Designed For

Automotive and aviation maintenance training programs
Trade schools and community college electronics courses
Self-study for ASE, A&P, or military MOS certification prep

What Students Will Measure

Measurement	Normal Reading
CAN_H to GND	~2.7V
CAN_L to GND	~2.2V
CAN_H – CAN_L (differential)	~0.5V
Termination resistance (correct)	60 ohm
Termination resistance (fault)	120 ohm

Interactive CAN Diagnostic Simulator

A free browser-based demo that mirrors this board. Pick any of the five faults and see exactly what a multimeter would show you, measurement by measurement.

Watch the live waveform and the averaged meter readings side by side
See where the leads go for every reading, and why the differential is measured across the pair instead of to ground
Flip the key between on and off to see why voltage and resistance are never measured at the same time
Compare each reading against its known-good value, with out-of-spec readings flagged

▶ Open the CAN Diagnostic Simulator in your browser

How to use offline: Use the download button on that page to save the demo as a single HTML file. Double-click it to open in any browser — no internet needed.