We asked our customers what they were looking for in an American-made run stand, then spared no expense building one that can be adapted to fit most any internal combustion engine. Some modification may be required for your specific application, but the standard set up will fit any big block, small block, LS, LT as well as many others that take the cross bolt style front mount. The threaded uprights allow you to build your own as you see fit as well for future engines that have different configuration.

Every American-Made Universal Run stand comes with the following features and benefits:

• Adaptable to All American V8 Engines
• Adaptable to most Light and Medium-Duty Diesel Engines
• Custom Brackets for Other Engines Available
• Test Run and/or Heat Cycle Most Auto and Diesel Engines with or without Transmission Attached (Depending on Length)
• Two Adjustable Front Engine Pedestals
• Two Front Engine Mount Brackets & Hardware (Cross bolt style)
• Adjustable Rear Bell Housing Mount System (Pre Drilled for GM on One Side of Each Bracket, Others Available)
• Adjustable Front & Rear Cross Members
• Ships Pre-Assembled from West Virginia
• Powder Coated framework & Plated Hardware
• Aluminum Radiator Mounted to Folding Handle Assembly
• Hinged Work Surface with 25” by 6” by 4” Tool Box
• Radiator Mount Folds Down for Storage and Transportation
• 6″ Cast Iron Castors with Locks on Two
• Multi-Position Dash Panel
  
  • Tachometer
  • Coolant Temp Gauge with Sender
  • Oil Pressure Gauge with Sender
  • Vacuum/Boost Gauge Mechanical
  • Voltmeter
  • Throttle Lever
  • Accy Switch
  • Fan Switch
  • Keyed Ignition
  • Emergency Stop
• Control Panel &  Wire Harness Manufactured in the USA
• Moveable Battery Tray with Battery Box
• Starter Relay in Control Panel
• Multi position Fuel Tank with AN Male Fittings
• Complete Cooling System, Including Dual-Fan Radiator, Full Fan Shroud, Drain Valve. (Multi Outlet Radiator Available)
• USA-Based Support by DAKTIC & Cutaway Creations